GUIDEResources

Transformer core RFQ guide

Use this checklist to define the manufacturing scope before price and delivery are confirmed.

RFQ checklist

Twelve inputs for review

1 / Core drawing: PDF, DWG or DXF; include drawing number, revision, units and assembly interfaces
2 / Lamination schedule: Joint sequence, holes, notches and piece identification when available
3 / Application: Transformer type and rated power in kVA or MVA
4 / Voltage: Primary and secondary voltage; insulation level where specified
5 / CRGO grade: Specified GOES grade, or state that a recommendation is required
6 / Thickness: Nominal material thickness
7 / Loss requirement: Target or acceptance limit with its test basis
8 / Supply format: Slit coil, cut laminations, pre-stacked packets, stacked core, assembled core, SKD or CKD
9 / Quantity: Number of cores, sets or repeat batches
10 / Destination: Port, country and named delivery point
11 / Packing: Route, storage, lifting, unloading and marking requirements
12 / Schedule: Required date and whether it is fixed or indicative

Mark unknown items as open. A firm manufacturing release still requires an approved drawing or complete dimensional definition.

Response

Manufacturing review: Manufacturability and open drawing points
Material and scope: Confirmed material, handover point and assembly responsibility
Commercial response: Quotation and schedule against the confirmed scope
Documents: MTC, dimensional report, photographs or conformity documents when agreed

This guide is a preparation checklist. Use the contact page for the enquiry and attach drawings through the communication channel you choose.

RFQTechnical review

Send the drawing and mark any item that is still open. We will return the technical questions before production release.